New Driveways & RV Pads in Eaton Rapids, MI
Eaton Rapids and the rural stretches of Eaton County have heavy clay soil that grinds gravel into mud if it is not built on a proper base. We dig out, install fabric where needed, lay 21AA limestone base, and finish with a 23A driveway top so the drive holds up to wet springs.
About Our Work in Eaton Rapids
Eaton County has heavy clay soil that needs proper base prep.
New driveways and RV pads are not just dump-and-go jobs. We start with site evaluation, proper excavation, a compacted base layer, then finish with the right surface aggregate for the load. Whether you are building a brand new home or carving out an RV pad on the side of your property, we handle it from bare ground to finished surface.
Recent project areas:
What’s Included
Every new driveways & rv pads job in Eaton Rapids includes the full scope below. No surprise extras, no shortcuts.
Brand new driveway construction (gravel)
RV and travel trailer parking pads
Boat and equipment storage pads
Site evaluation and layout
Excavation and removal of topsoil and unsuitable material
Compacted base layer (typically 4-6 inches of base stone)
Surface aggregate (typically 2-3 inches of finish gravel)
Proper crown and drainage on every install
Edge definition and hand-finishing
How It Works
Site Visit
Mark walks the area with you, discusses the intended use (daily driver vs. RV vs. boat), and lays out the dimensions.
Excavate
Topsoil, sod, and unsuitable material are removed to depth. Most pads need 6-10 inches excavated to make room for proper base and surface.
Base Layer
Compacted base stone goes down first. This is what holds up to the weight without settling.
Surface Layer
Finish aggregate (typically 1 1/4 crushed limestone) is spread, leveled, and compacted.
Drainage & Crown
Driveway is crowned for water runoff. Pads are pitched gently away from buildings.
Questions from Eaton Rapids Homeowners
Do you serve Eaton Rapids, MI?
Yes. Eaton Rapids is 16 miles from our shop in Mason, MI, about a 25-minute drive. We work in Eaton Rapids regularly and treat it as part of our core service area.
How quickly can you get to a job in Eaton Rapids?
For estimates, usually within a couple of days. For the actual work, scheduling depends on the season — busy spring and fall mean 1 to 3 weeks out, off-season much faster. Mark will give you a real timeline at the estimate, not a vague "we'll get to it."
How much excavation does a new driveway need?
Most residential driveways need 6-8 inches excavated to make room for a proper base. RV pads usually need 8-10 inches because of the heavier loads.
How much does a new gravel driveway cost?
Cost depends on length, width, and how much excavation is needed. A typical 100-foot residential driveway runs in the $3,000-7,000 range. Free estimates always.
Do RV pads need to be different from regular driveways?
Yes. RVs put a lot of weight on a small footprint, so RV pads need a thicker base layer and a heavier-duty aggregate. We size it for the actual RV.
How long does a new install take?
Most residential driveways are done in 1-2 days. RV pads are typically done in a single day.
New Driveways & RV Pads in Other Mid-Michigan Cities
We work new driveways & rv pads jobs across the greater Lansing area. Pick your city to see local details.
Other Services We Do in Eaton Rapids
We aren’t just driveways. Here’s the full list of what we handle locally.
Get a Free Estimate in Eaton Rapids
Mark will come out to your property in Eaton Rapids, walk the job, and give you an honest quote. No pressure, no obligation.